Triton Audio FetHead Filter

519,00 kr.

FetHead Filter er en Fethead version med et indbygget 6dB/octave high pass filter med en cutoff frekvens på 220Hz (ønsker om andre frekvenser kan bestilles). FetHead Filter er designet til mikrofoner med ekstra  proximity effect / low frequency response, som fx. båndmikrofoner. De komponenter der udgør filteret er ikke direkte i signalvejen, men er derimod tilføjet til komponenterne som sætter gainen i FetHead Filterets forstærker, hvilket gør den frekvens afhængig. På den måde bevarer man den lydmæssige karakter der er så tilfredsstillende for det menneskelige øre.

Beskrivelse

Philosophy
FetHead is a high quality, phantom powered in-line preamplifier providing improved sound for ribbon and dynamic microphones. The electronics are housed in a robust metal chassis with a balanced 3-pole female XLR input and a balanced 3-pole male XLR output, rugged enough for use at home, in the studio or on tour.

Which microphones benefit
In short, we noticed an improvement on all tested dynamic microphones. A Shure SM57 or SM58 for instance, sounds more responsive over a broader frequency range. When mated with a high-end dynamic microphone like a Sennheiser MD441, or Shure SM7 FetHead really shines. Ribbon microphones benefit greatly too because of a much better impedance match, which lessens the load on the microphone, giving it better transient response characteristics. FetHeads high quality, low noise signal amplification also extends the usable range of a ribbon microphone, by making it more suitable for recording softer passages without introducing noise issues.

Protects the microphone
Some ribbon microphones do not tolerate phantom power, FetHead’s circuit uses Phantom power but shields it from its input (and the microphone’s output), as a result it offers effective protection to the microphone.

Low noise
Fethead uses low noise jfets configured as a double class a amplifier. Jfet’s are among the most quiet amplifying elements available today. The calculated noise figure of FetHead is lower than we are able to measure.

How it works
Attach FetHead on to a balanced microphone cable and plug it in a dynamic microphone, switch on phantom power and enjoy FetHeads Natural open sound!

 

Features

  • Ultra low noise Class A JFet amplifier
  • 20db amplification (@ 1000 ohm load)
  • double single ended amplifier topology
  • Hand matched jFets
  • Shielded enclosure
  • Z-in 22k
  • 18-48 v phantom power

     

Anmeldelser

Der er endnu ikke nogle anmeldelser.

Kun kunder, der er logget ind og har købt denne vare, kan skrive en anmeldelse.