Triton Audio FetHead

5.00 ud af 5 baseret på 1 kunde anmeldelser
(1 kundeanmeldelse)

895,00 DKK

Med denne lille preamp direkte på kablet, kan du markant forbedre lydkvaliteten og give mere output på din ribbon, eller dynamiske mikrofon.
Du får en mere kontrolleret dynamik, og et bredere frekvensområde, og mindre støj !
Prøv feks at bruge den på din SM57/58 eller dine ribbons.
For Ribbon brugere, er du desuden fri for den evige frygt for at sende phantom ind i din mikrofon.

 

Kategori:

Beskrivelse

Philosophy

Inspired by the positive results of the BigAmp we wondered if a phantom powered, high quality preamp preceding the microphone cable could improve the sound quality of a ribbon or dynamic microphone. the results were more then convincing. Enter FetHead, our latest innovation in phantom powered preamp design. While testing FetHead we noticed an overall increase of sound quality and a change of tonal character of the attached dynamic microphone towards a more open, controlled sound.

Which microphones benefit

In short, we noticed an improvement on all tested dynamic microphones. A Shure SM57 or SM58 for instance, sounds more responsive over a broader frequency range. When mated with a high-end dynamic microphone like a Sennheiser MD441, or Shure SM7 FetHead really shines. Ribbon microphones benefit greatly too because of a much better impedance match, which lessens the load on the microphone, thus giving it better transient response characteristics. FetHeads high quality, low noise signal amplification also extends the usable range of a ribbon microphone, by making it more suitable for recording softer passages without introducing noise. Some ribbon microphones do not tolerate phantom power, FetHead´s circuit uses Phantom power but shields it from its input (and the microphone´s output), as a result it offers effective protection to the microphone.

Low noise

Fethead uses low noise jfets configured as a double class a amplifier. Jfet´s are among the most quiet amplifying elements available today. The calculated noise figure of the FetHead based on the jfet´s datasheet is lower than we are able to measure.

Specs 

    • Ultra low noise Class A JFet amplifier
    • 20db amplification (@ 1000 ohm load)
    • double single ended amplifier topology
    • Balanced output
    • Lots of headroom
    • Z-in 22k
    • 18-48 v phantom power
    • Free worldwide shipping

 Reviews:

http://www.podcast.tv/video-episodes/triton-audio-fethead-vs-cloud-microphones-cloudlifter-cl-1-17958195.html

 

1 visning af Triton Audio FetHead

  1. 5 ud af 5

    Jeg kan ikke huske hvornår jeg har fået så meget for 895 kroner!!!!

    Min gamle B&O bånd mikrofon har været flittigt brugt på min guitar forstærker og andre kraftige kilder i de sidste mange år, og jeg elsker den mikrofon. Den har dog ikke kunnet bruges til andet, da den har alt for meget grundstøj/sus.

    Med en Fethead kan min gamle B&O mikrofon pludselig bruges til ALT….!

Tilføj en anmeldelse